Embermont RGB LED Strip Light Kit – Color-Changing Strip with 44-Key Remote, Cut to Length, 5 m

• One strip, the whole color range. 5050 RGB chips mix red, green and blue in each diode, so you pick a color from the remote rather than being stuck with the one the strip was made in.
• 44-key remote. Colors, brightness, fade and flash modes all sit on one flat handset, so you change the room from where you are sitting instead of reaching behind the furniture.
• Cut it to the run you have. The strip is marked at regular intervals with copper solder pads, so you shorten it to fit a shelf, a step or a cabinet instead of coiling the slack out of sight.
• Waterproof coating. The waterproof version is sealed in clear silicone over the board, so it copes with a kitchen, a bathroom shelf or a covered porch. The bare board version is for dry runs indoors.
• Dimmable, and rated for a long life. 60 LEDs per metre at 12 to 14 lumens each, dimmable from the remote, with a rated life of 50,000 hours.
• Sticks where you put it. A flat 10 mm strip on an adhesive back follows a straight run or a gentle curve and disappears into a shadow gap.

What it is for

Light you do not look at directly: behind a shelf, under a kitchen cabinet, along a coving, up the back of a headboard. The strip hides in the gap and what you see is the wash of color on the wall behind it.

Setting it up

Decide the run first, cut the strip at the nearest marked point, peel the backing and press it down along a clean dry edge. Connect the controller lead and pair the remote by pointing it at the small receiver box.

Which version to choose

The waterproof strip is coated in clear silicone and suits damp or dusty places. The bare board strip has no coating, sits a little flatter in a tight channel and is for dry indoor runs only.

What arrives

The LED strip, the inline controller with its receiver and the 44-key remote handset.

Specifications